Installing the drivers

This page explains how to install the Apocalypse drivers from the CD-ROM using Windows Plug and Play.

Note that our recommendation is that you use the Apocalyse Installer to install the software, as it is quicker, easier, and more comprehensive than using Windows Plug and Play. However, if you prefer to use Windows Plug and Play, follow the instructions below.

1. When your computer has restarted, insert the Apocalypse CD-ROM into the appropriate drive.
   
   
2. A window is displayed saying that Windows has found new hardware. Select Driver from Disk provided by Hardware Manufacturer, and click OK.
   
   
3. A window is displayed asking for the location of the software. Browse to the folder apoc3D\drivers on the Apocalypse CD-ROM. After browsing, click OK.
   
   
4. Click OK to install the drivers.
   
   
5. When the drivers have been installed, a message is displayed asking whether you want to restart Windows. Click Yes.
   
   When your computer has restarted, Apocalypse 3D is ready to use.