Notes on PFS Write, File, and Report
------------------------------------

PFS Write, File, and Report came on copy protected diskette.  To create a 
usable copy, you must use Teledisk to write the diskette image to a 360k 
disk.  Teledisk v2.12 can be found at:

    ftp://tvdog.shacknet.nu/tandy1000/system/old/teled212.zip
    ftp://ftp.oldskool.org/pub/tvdog/tandy1000/system/old/teled212.zip 

Note if installing on a Tandy 1000-series that Teledisk is not compatible 
with the floppy controller on some models.  You may need a second machine 
with a 5-1/4" drive to create an install disk.

These programs will only install from a 360k diskette in drive A:.  You 
must have a 5-1/4" drive to install.  If you have an original 1000, 1000A, 
SX, TX, EX, or HX and your 5-1/4" drive is drive B:, you can make it drive 
A: temporarily by hitting F3 at boot time.  If you have a later model Tandy 
1000-series, you can use the system setup program to make your 5-1/4" drive 
be the A: drive - if you don't see the option, use /A, i.e., SETUPTL /A.

To install on a hard disk, first create a directory on your hard disk where 
the program should reside, ex.:

    C:\> MKDIR PFSFILE

Note, the setup program will *not* create an install directory.  

To install, run the Setup program, not the Install batch file.  When asked 
for the "Drive name for the hard disk:" by Setup, enter the full path to 
the directory where you want the program installed, ex., "C:\PFSFILE".

When installing PFS File or Report, you should first select a work drive 
using the Setup program.  When asked for the "Work drive name:", give the 
full path to the install directory, ex., "C:\PFSFILE".

Check the installed directory for installed versions that do not require
Teledisk or a 5-1/4" diskette drive (those versions, however, do not allow 
you to specify the install directory).