Installing the drivers

This page explains how to install the Apocalypse drivers from the CD-ROM using Windows Plug and Play.

Note that our recommendation is that you use the Apocalyse Installer to install the software, as it is quicker, easier, and more comprehensive than using Windows Plug and Play. However, if you prefer to use Windows Plug and Play, follow the instructions below.

Software installation differs depending on whether you are upgrading drivers in Windows 95, or Windows 98. Click the operating system you are using.

Windows 95

If you know which build of Windows 95 you are running, continue for build 4.00.950 or 4.00.950a or 4.00.950b (also known as OSR2).

Otherwise follow these instructions:

1. Click the Start button, point to Settings and click Control Panel.
   
   
2. Double-click the System icon to open the System Properties Window.
   
   
3. Click the General tab. The build number is located in the System section, under the ‘Microsoft Windows 95’ line.
   
   
4. Continue for build 4.00.950 or 4.00.950a, or 4.00.950b (also known as OSR2).